7 Replies to “How to create a Pick and Place Program using Robot Studio

  1. Hey dude,
    Great tutorial. I would just like to ask you though where I could find the Vacuum gripper you were using, as I can’t seem to find it anywhere. Would be grateful if you could help me out.

  2. Hi there!

    Thank you so much for this tutorial. It’s really one I can follow and undesrtand. It really helps me in my first steps in Robotstudio.

    It would be a great deal for me if you could share with me this gripper you are using and/or any other simple grabbing tool that I could use for my small robot simulation project for my university.

    I would be extremely grateful because I’ve searched all over the internet and I can’t seem to find anything simple that can be used in the free Robotstudio 6.07.1 that is available now!

    Thanks so much in advance

  3. Thank you for this great tutorial. May I ask you also for the gripper to follow along your video?

    Trying to complete a college assignment using RobotStudio and is kind of frustrating the scarce amount of resources to properly learn how to get started with things like a smart component.

    Thanks again for your video and time.
    Best,
    João Paulo

Leave a Reply

Your email address will not be published. Required fields are marked *